Close
New Products

7" Premium 40 Pin Male to Male Jumper Wires

These premium jumper wires are 7" long. They have 0.1" male header on both end. They can be installed next to each other on standard pitch 0.1" header. 40 jumper wires in 4 set of each of ten rainbow color. You can always pull the ribbon wires off to make individual jumpers, or keep them together to make neatly organized wire harnesses.
$5.99

2 Channel 12V Relay Module

The 2 channel 12V relay module provides 2 optically isolated inputs that accept a wide range of voltage. This is a great way to switch on or off AC or DC loads using your Arduino.
$5.99

4 Channel 5V Relay Module

The 4 channel 5V relay module provides 4 optically isolated inputs that accept a wide range of voltage, including the 3VDC and 5VDC signals available on the Arduino. This is a great way to switch on or off AC or DC loads using your Arduino.
$7.99

8 Channel 5V Relay Module

The 8 channel 5V relay module provides 8 optically isolated inputs that accept a wide range of voltage, including the 3VDC and 5VDC signals available on the Arduino. This is a great way to switch on or off AC or DC loads using your Arduino.
$10.99

HY-SRF05 Ultrasonic Distance Sensor

Ultrasonic ranging module HY-SRF05 provides 2cm - 400cm non-contact measurement function, the ranging accuracy can reach to 3mm. The module includes transmitters, receiver and control circuit.
$4.99

BMP085 Barometric Pressure Sensor

This low-cost sensor breakout board which can be connected directly with a microcontroller via a I2C bus. Bosch's BMP085 is a rock-solid barometric pressure sensor. It features a measuring range of anywhere between 300 and 1100 hPa. As a bonus, the BMP085 also provides a temperature measurement, anywhere from 0 to 65°C.
$7.99

ENC28J60 Ethernet Breakout Board

ENC28J60 Ethernet Module utilizes the new Microchip ENC28J60 Stand-Alone Ethernet Controller IC featuring a host of features to handle most of the network protocol requirements. The board connects directly to most microcontrollers with a standard SPI interface with a transfer speed of up to 20MHz.
$8.99

HDMI Male to VGA Female Cable

If you want connect your Raspberry Pi to a monitor or project with VGA input, this is the cable you need. This HDMI male to VGA female cable can convert the HDMI digital signal to VGA analog signal.
$9.99